This is my workshop. After building all the wing ribs, I plan on building a 4' x 8' workbench which will go in the middle. I will assemble the wings on it and will build the fuselage on it. I'd better get it nice and level!
Entrance to the garage, my safe, and storage along the entire wall of the garage. All the storage is non-workshop related. Table saw in the foreground.
Two rolling storage cabinets, drill press, and air compressor.
Up until just a few weeks ago, all my tools were disorganized and in various locations throughout the garage, mostly tucked away out of sight or in ugly piles. Now, they're all hanging from pegboard.
These are two new work benches. The one on the left isn't quite finished. The miter saw will go between them so that they will act as infeed and outfeet tables, besides workbenches. Each has a nice sized shelf underneath for storage. The tables are 2' x 4' and are about 37" high (36" legs + adjustable feet + 3/4" MDF tops). The tool under the bench on the right is an oscillating belt sander.
Table saw and router table.
Screws, nails, plate joiner (aka biscuit joiner), a couple orbital sanders, Tormek knife sharpening system, jig saw, pneumatic brad nailer, Milwaukee drill, cordless circular saw, Skil worm drive saw, and router.
No comments:
Post a Comment